Car seat electric drive controller kit

For the correct choice of the operating mode of the device (as well as the method of its connection), determine the desired algorithm for its operation, that is: Under what circumstances (conditions) the seat moves forward (into the working position) and, accordingly, back ATTENTION !!! Moving the driver's seat forward (to the working position) is possible (besides fulfilling other conditions) ONLY when the car engine is running !!! Also consider how to manually adjust power seats


Driver's seat Programming NOTE Programming the driver's seat is recommended to be performed by the direct user of the vehicle, while taking into account its weight category


1 Sit on the seat (make yourself comfortable)

2 Start the car engine

3 Switch on (MANDATORY !!!) all powerful energy consumers of the car (dimensions, low beam, heaters for rear window and rear-view mirrors, fan speed of the climate system to maximum, turn on the air conditioner)

4 Adjust the position of the seat to anyother than the rearmost position

5 Press the controller temporary blocking button three times in a row and keep it pressed

6 The seat will move to the rearmost position

7 Adjust the working position of the seat using the horizontal buttons of the joystick (the most comfortable for you while driving) 8 Switch off button for temporary blocking of the controller (put it in the released state)

Programming completed NOTE Due to many factors affecting the operation of the device, it is possible to deviate the movement of the seat from the programmed position by a distance of + \ 5 mm, which is not a malfunction of the devicedeviation of the seat movement from the programmed position by a distance of + \ 5 mm is allowed, which is not a malfunction of the devicedeviation of the seat movement from the programmed position by a distance of + \ 5 mm is allowed, which is not a malfunction of the device


Passenger seat Calibration NOTE Calibrate the passenger seat without a rider (passenger) 1 Start the car engine 2 Adjust the position of the passenger seat to any position other than the rear seat 3 Press the controller temporary blocking button three times in a row and keep it pressed.


Seat will move to the rearmost position, then move to the frontmost position, then move to the rearmost position again, and then move 25% of the total travel forward 5 Stop the car engine.


The seat will move to the rearmost position, then move to the frontmost position, then it will again move to the rearmost position, after which it will move 25% of the total travel forward


If you are not satisfied with this position of the passenger seat,then use the horizontal buttons of the joystick to adjust the seat position convenient for you.


Turn off the temporary blocking button of the controller (put it in the released state) Calibration is complete


NOTE If there is a long pause between steps 5 and 6, it means that this car is experiencing a slow voltage drop in the electrical circuit Accelerate the voltage drop by switching on the dimensions of the car or simply blink the high beam headlightsthis car has a slow voltage drop in the electrical circuit Accelerate the voltage drop by turning on the dimensions of the car or just blink the high beam headlightsthis car has a slow voltage drop in the electrical circuit Accelerate the voltage drop by turning on the dimensions of the car or just blink the high beam headlights

Build your free website with Moonfruit